• Doggett 20-7-10 Basic Balance

    • Doggett 20-7-10 Basic Balance

    Doggett

    MSRP: $67.95
    $63.75
    (You save $4.20 )
    (No reviews yet) Write a Review
    SKU:
    DG-1014
    Product Summary:
    Contact us for availability and shipping quotes to purchase. For Correcting High pH Soils in Combination with Fertilizer.
    Adding to cart… category.add_cart_announcement

    Product Description

    20-7-10 Basic Balance

    For Correcting High pH Soils in Combination with Fertilizer.  A Good General Purpose Formula for Areas with Alkaline Soils.

    Contains slow release N. Elemental sulfur to reduce pH and condition the soil. A high percentage of both FEDTA and FEDDHA iron to correct iron chlorosis. Recommended for soils with pH 7 and higher.

    30 lb bag

    GUARANTEED ANALYSIS

    Total Nitrogen (N) 20.00%
    10.0% W.I.N.
    10.0% Urea N
    Available Phosphate (P2O5) 7.00%
    Soluble Potash (K2O) 10.00%

    Secondary Elements
    Iron (Fe) 0.4%
    .3% EDTA Cheleated Iron (Fe)
    .1% EDDHA Cheleated Iron (Fe)
    Magnesium (Mg) 3.0%
    Sulfur (S) 12.0%

    Nutrients derived from: Ureaform, Urea, Sulfate of Potash, Iron EDTA, Iron EDDHA, Magnesium Oxide.

    NON PLANT FOOD INGREDIENTS: Humic acid 2% per total wt., Citric acid .5% per total wt.

    DOGGETT'S BASIC BALANCE is formulated for the professional. Because of it’s slow release N content, and the elemental sulfur, it does not dissolve completely, but with a strong agitation remains in suspension. Therefore it should be used with power spraying equipment with good agitation.

    APPLICATION
    Injection holes should be 4 to 6 inches deep starting out from the main trunk or stem, and then spaced approximately 3 ft. apart on a grid or in concentric circles. A site judgement should be made to determine what the entire root area (injection area) should be, however, a rule of thumb would be 150 gals over 2000 sq. ft.

    Dilution Table

    Lbs. of Basic Balance per gals. of water
    15 100
    30 200
    75 500

     

     

     

     

    Following the grid method outlined you should inject 16 oz. of fertilizer solution at each point.

    To Calibrate: We suggest that you discharge your tree feeding needle into a measured vessel noting the time it takes to discharge 16 ozs. This will probably take approx. 3 seconds. Use the same count and cadence when injecting into the soil.

    Trunk Diameter Rate of Application: Use same dilution rates shown in table. Apply the dilute solution at the rate of 5 Gals. per inch trunk diameter (DBH). Using the grid or concentric circle technique, inject 75 gals. per 1,000 sq. ft.

    Product Videos

    Custom Field

    Product Summary Contact us for availability and shipping quotes to purchase. For Correcting High pH Soils in Combination with Fertilizer.

    Product Reviews

    Write a Review